Mar 23, 2009 - I have a Marksman H50T13 remote starter and had to change the batteries in my remote. I also recently replaced the car battery. Car Alarm Marksman Extreme X9 Owner's Manual Extreme series automotive security and remote start system (20 pages) Car Alarm Marksman Marksman Extreme Series X9 Installation Manual. ![]() • Installation and Owner’s Manual Model: X3 For Technical Assistance, please call (800) 638-3600, or visit www.magnadyne.com This device complies with part 15 of the FCC rules. Outlook for mac 2011 unable to establish a secure connection. Operation is subject to the following two conditions: (1) This device may not cause harmful interference; and (2) This device must accept any interference received, including interference that may cause undesired operation. • Table of Contents Component Installation.2 Wiring White 12-Pin Main Harness. • Wiring Harness Quick Reference HC4 12-Pin Main Harness Yellow +12VDC Ignition Input Green (-) Common Door Pin Input Blue (-) Hood / Trunk / Auxiliary Trigger Input Violet (+) Common Door Pin Input Orange (-) Ground when Armed Output Open No Connection Red/White (-) 300mA Programmable Channel 3 (Trunk) Output Black. • Wiring (continued) Red/White Wire: (-) 300mA Programmable Channel 3 Output (Default Trunk Release) The Red/White wire is typically used to release the power trunk by remote. An additional relay is usually required as shown in the diagram below. This wire can also be programmed for Domelight Supervision Control or 2nd unlock function (See Alarm Feature Programming to change the setting) Output to Power Trunk Switch Red/White Wire. • Wiring (continued) HC3: Black 3-Pin Door Lock Harness Blue Wire: (-) Door Unlock Control Connect the Blue wire to the unlock wire from the door lock switch. If the door locking system is not a (-) trigger system, additional relays will be required. Green Wire: (-) Door Lock Control Connect the Green wire to the lock wire from the door lock switch. • Optional Wiring Diagrams Red/White Wire: (When programmed for (-) Domelight Supervision Output) When Programmed for this function, the Red/White wire provides a (-) output to turn on the vehicles interior light when the alarm has been disarmed. The domelight will stay on for 30 seconds unless the ignition key is Output to Dome Light (+ or -) Red/White Wire To Constant +12 Volts. • Programming the Transmitter Step 3 Step 5: Step 4 Exit Program Mode Press the “Lock” button on the first Repeat for each additional When finished, turn Off the ignition transmitter until you hear a transmitter. Key or wait for 15 seconds to get out confirmation chirp/beep. • Alarm Feature Programming (continued) Press TX Button Press TX Button Press TX Button Press TX Button Press LED Flash/ Valet One Chirp Chirp Two Chirps Three Chirps Switch (Default Setting) O “ ” f f O “ ” n Automatic Arming Automatic Arming Manual Arming without Door Locking. Install os x 10.9 for turbo tax 2016. • Shock Sensor Testing and Adjustment Step 6 Step 4 Step 5 Decrease Increase 1. Press and hold the LOCK and 1. Press the LOCK button to To exit the shock sensor test mode, UNLOCK buttons together for 2 increase sensitivity by 1 step turn ignition “On”. • Owners Manual (Continued) Button Function: Transmitter Button System Function / Remark Action Press and Release Arm/Lock Doors Press Twice Arm/Lock Doors + Delete Shock Sensor (2nd Long Beep) Press and Release Progressive Car Finder (Functions 30 Seconds After Armed) Press and Release Disarm/Un-Lock Doors Press and Hold for 1.5 Seconds Channel 3 Activation (Release Trunk as Default) • Owners Manual (Continued) F.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |